Loading...
 

Wiki Home

The Marvell MACCHIATObin is a family of cost-effective and high-performance networking community boards targeting ARM64bit high end networking and storage applications.

With a offering that include a fully open source software that include U-Boot, UEFI, Linux, Yocto, netmap, ODP and DPDK, the Marvell MACCHIATObin Single Shot and Double Shot are optimal platforms for community developers and Independent Software Vendors (ISVs) to develop networking and storage applications.

Both MACCHIATObin flavors are powered by Marvell ARMADA 8040 quad-core SoC chipset that runs up to 2GHz.

Technical Specifications


The MACCHIATObin family was envisioned to bring affordable ARM-based development boards to the community. In line with this objective, MACCHIATObin introduces two new products: the budget-minded MACCHIATObin Single Shot and the high-performance, full-featured MACCHIATObin Double Shot.

Key technical differences between the two products are shown in the table below.

 

ComponentMACCHIATObin Single ShotMACCHIATObin Double Shot
SoCMarvell ARMADA 8040Marvell ARMADA 8040
ProcessorQuad core Cortex-A72 (up to 1.6GHz)Quad core Cortex-A72 (up to 2GHz)
AccelerationsPacket Processor
Security Engine
DMA engines
XOR engines for RAID 5/6 acceleration
Packet Processor
Security Engine
DMA engines
XOR engines for RAID 5/6 acceleration
Other Features IO virtualization
SBSA
IO virtualization
SBSA
MemoryDDR4 DIMM slot with optional ECC and single/dual chip select supportDDR4 DIMM slot with optional ECC and single/dual chip select support
NetworkingDual 10GbE (1/2.5/10GbE) via SFP
2.5GbE (1/2.5GbE) via SFP
1GbE via copper
Dual 10GbE (1/2.5/10GbE) via copper or SFP
2.5GbE (1/2.5GbE) via SFP
1GbE via copper
FlashSPI FlashSPI Flash
Storage3 X SATA 3.0 connectors
MicroSD connector
eMMC
3 X SATA 3.0 connectors
MicroSD connector
eMMC
High speed expansionPCI x4 3.0 slot
USB 2.0 Headers (Internal)
USB 3.0 connector
PCI x4 3.0 slot
USB 2.0 Headers (Internal)
USB 3.0 connector
Low speed expansionMarvell TDM module headerMarvell TDM module header
Development and Debug interfacesConsole port (UART) over microUSB connector
20-pin Connector for CPU JTAG debugger
2 X UART Headers
Console port (UART) over microUSB connector
20-pin Connector for CPU JTAG debugger
2 X UART Headers
Power12V input via DC Jack
ATX type power connector
12V input via DC Jack
ATX type power connector
Form FactorMini-ITX (170 mm x 170 mm)Mini-ITX (170 mm x 170 mm)
Optional AccessoriesAdditional DDR4 DIMM options
12V DC power supply
ATX power supply
Standard Mini-ITX Case
Additional DDR4 DIMM options
12V DC power supply
ATX power supply
Standard Mini-ITX Case
PriceFrom $269.00From $369.00


For a full list of schematics electrical design and layout changes from Revision 1.2 to Revision 1.3, download the official SolidRun PCN on the link below: